Powermatic PF-BS Manual de usuario

Operating Instructions and Parts Manual Powered Stock Feeder for Band Saws Model PF-BS WMH TOOL GROUP 2420 Vantage Drive Elgin,

10 3. Tighten the handle (A, Figure 3). If necessary, move the Fence slightly to bring it parallel with the blade. 4. When satisfied, mark the loca

11Grounding Instructions Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be

12Adjustments Fence Movement To move the fence toward or away from the saw blade, loosen the lock handle (A, Figure 10) and rotate the knob (B, Figur

13Changing Feed Rate 1. Loosen the two hex nuts (one is shown in Figure 13) that hold the motor to the motor mount. Use a 12mm wrench. Do not remove

14 2. Set the desired rate of feed on the Stock Feeder by moving the belt to the proper pulley grooves. Proper rate of feed will depend upon the har

15 Arm Axis Keep the axis of the arm lubricated with a good quality general purpose grease, inserted through the grease fitting (Figure 18). Fen

16Feed Rate/Belt Position

17Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848 between

18Parts List: Fence Assembly Index No. Part No. Description Size Qty 1...PFBS-101 ... Roller Fence...

19Fence Assembly

2 This manual has been prepared for the owner and operators of a Powermatic Model PF-BS Stock Feeder. Its purpose, aside from machine operation, is t

20Parts List: Feeder Assembly Index No. Part No. Description Size Qty 1...BB-6202ZZ... Ball Bearing...

21Index No. Part No. Description Size Qty 55...TS-1550061 ... Flat Washer...

22Feeder Assembly

23Electrical Connections

24 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com

3 Table of Contents Warranty and Service ...

4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 blahblahblah 21. Make your workshop child proof with padlocks, master switches or by removing starter keys. 22. Give your work undivided attention

6 Introduction This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Model PF-BS Stock Feeder and Fence

7 Unpacking Remove the plastic from around the Feeder and Fence, and check for shipping damage. Report any damage immediately to your distributor and

8 Mounting Hole Location NOTE: Dimensions are in inches, hole sizes are metric. Figure 1

9 Assembly and Installation Tools needed for assembly: 8.5mm drill bit M10 x 1.5P tap 17mm wrench Remove the clear plastic from around the Stock Fe